How do I setup controls for ICR2? How do I race with my wheel? For some reason the game won't let me change the controls. When I push enter to change them it just changes the controls to "mouse x". What do I do?

are you installing a new wheel? If so, did you extrace all previous software and drivers?

Are you able to calibrate the wheel from the game? Does ICR2 see the wheel?

when are you pushing enter?

Yes I am able to calibrate it(From inside the game as well) but like i said it screws up when I try to change the cointrols.

This post was last modified: 03-19-2007 12:45 PM by sunoco.

Does anyone know how to fix this? It is very annoying. I simply can't drive properly with the keys.

I assume you're using the DOS version? if so you could make a boot disk, and then go edit it and take out the mouse drivers.  I did that once for a game, maybe someone else could actually explain exactly how it's done since that was a long time ago

This post was last modified: 03-20-2007 01:20 AM by OI812.

I had this problem and the fix is sorta simple. Sorta.

What version of ICR2 are you running?

DOS or windows?

Version 1.00, 1.01 or 1.02?

Most likely you need to update to version 1.02 but answer the above questions first and we'll go from there.

I have 1.00. I suppose I should patch it?

Yeah.

1.00 has two bad bugs:

1) Setting the controls defaults to the mouse

2) Cars will pass under yellow flags.

I have the 1.02 patch for DOS but it is almost 8M. I can't upload it to the board and it's too big to email.

Any ideas how I can get it to you?

There's no need, it is on this page as well:

http://www.3dgamers.com/games/indycarracing2/downloads/

What a handy site!